Quiet often when creating auto circles around the outside of a circle, my probe will touch the table while doing the circular move between touches. These touches are quiet high off of the table, and at the same depth. What is causing this? Here is an example:
CIR30 =FEAT/CONTACT/CIRCLE/DEFAULT,CARTESIAN,OUT,LEAST_SQR
THEO/<3,0,0>,<-0.0010004,0.0340143,0.9994208>,12.28,0
ACTL/<3,0,0>,<-0.0010004,0.0340143,0.9994208>,12.28,0
TARG/<3,0,0>,<-0.0010004,0.0340143,0.9994208>
START ANG=656.7,END ANG=1870.8
ANGLE VEC=<0.9973945,-0.0720285,0.0040016>
DIRECTION=CCW
SHOW FEATURE PARAMETERS=NO
SHOW CONTACT PARAMETERS=YES
NUMHITS=4,DEPTH=0,PITCH=0
SAMPLE METHOD=SAMPLE_HITS
SAMPLE HITS=0,SPACER=0
AVOIDANCE MOVE=NO,DISTANCE=0.394
FIND HOLE=DISABLED,ONERROR=NO,READ POS=NO
SHOW HITS=YES
HIT/BASIC,<5.356,-5.673,-0.005>,<0.3837161,-0.9229036,0.0317942>,<5.356,-5.673,-0.005>
HIT/BASIC,<8.663,-2.378,-0.005>,<0.9222954,-0.3862295,0.0140681>,<8.663,-2.378,-0.005>
HIT/BASIC,<8.695,2.289,-0.005>,<0.9274181,0.3738402,-0.011795>,<8.695,2.289,-0.005>
HIT/BASIC,<5.432,5.628,-0.005>,<0.3961212,0.9176803,-0.0308358>,<5.432,5.628,-0.005>
ENDMEAS/
