angularity

I have to construct a center plane between two planes and I get it, that I have to click on dist and construct a 3D plane, then call that my datum (we'll call that datum B) . After I construct the 3D plane, I have an Angularity call out, to the top of the part (we'll call that datum A). I have a MAX Material on the angularity call out also. (Dimensionally from the two planes) . My issue is.... on the CMM print out, its giving me the 'bonus', the correct width for the bonus, but its telling me that the angularity is OUT of tolerance by .100 plus?

Same with the other direct... that I construct dat C and the angularity call out is from A and B datums. Datum C is constructed the same way as datum B... 3D dist.

ALSO... when I look at my "actuals" / hits on the CMM... I do not see how these angularity call out can be OUT .100.

Any help will be appreciated! I'm sure I am missing something simple. Thanks

Henniger123 over 1 year ago

Hello,

Callouts are zero ? are you sure that whoever made the drawing knows what he is doing?

None of the specified surfaces have an "angle" <> 90° or 0° to the datums, that can only fail.

try the surface profile to ABC an all surfaces, including point J->H; G->P, at least that will work.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Henniger123 over 1 year ago in reply to Henniger123

you posted that twice, my bad, forget what i said,
that has already been answered
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel