Hi everyone, I am sending programs over to our customer and I was asked to send the programs over showing no deviations. Can I do this? They want all deviations showing 0.
I reset all feature measured values back to nominal then tried rerunning the dimensions but they wont reset back to Zero. Do I have to re dimension everything?
Running a program offline will NOT set everything back to THEO (nominal) values. It will set everything to TARGET values. So, if you had to change a target value, say, for a hole that is just a bit too far off nominal to run, it will set that hole to the target values.
Running a program offline will NOT set everything back to THEO (nominal) values. It will set everything to TARGET values. So, if you had to change a target value, say, for a hole that is just a bit too far off nominal to run, it will set that hole to the target values.