Hi everyone, I am sending programs over to our customer and I was asked to send the programs over showing no deviations. Can I do this? They want all deviations showing 0.
I reset all feature measured values back to nominal then tried rerunning the dimensions but they wont reset back to Zero. Do I have to re dimension everything?
NinjaBadger Cool I didn't know about this setting!
Is there a collection of useful settings editor settings and what they do?
I feel there is a lot of useful things in there but its just so hard to know about them!
What I have so far:
Option | UseISOCalculations -> Use ISO calculations for legacy commands
Option | DrawScansAsPoints -> Draws every scan point as an individual point
USER_AutoFeatures | ArcReductionAngle -> Changes the reduction angle for partial circles (i usually set it to 0)
Option | ShowStartupDialog -> Lets you set up if the routine picker dialog is shown automatically or not
Option | MostRecentFileList -> Lets you adjust how many routines are shown in the recent file list
NinjaBadger Cool I didn't know about this setting!
Is there a collection of useful settings editor settings and what they do?
I feel there is a lot of useful things in there but its just so hard to know about them!
What I have so far:
Option | UseISOCalculations -> Use ISO calculations for legacy commands
Option | DrawScansAsPoints -> Draws every scan point as an individual point
USER_AutoFeatures | ArcReductionAngle -> Changes the reduction angle for partial circles (i usually set it to 0)
Option | ShowStartupDialog -> Lets you set up if the routine picker dialog is shown automatically or not
Option | MostRecentFileList -> Lets you adjust how many routines are shown in the recent file list