Good Morning. I am fairly new to CMM programming so please don't mind me if I can't explain things properly. So one of our programs require that I use a 90° angled tip so when the tip is rotated at A0B0 my tip is taking points in X/Y direction. My issue is when I am calibrating, the entire probe changes orientation on PCDmis where the angled tip is now pointing down to Z-minus which messes up calibration either by crashing into the sphere or taking points too far from the sphere. I was able to calibrate this tip before on the same machine back in December, but it was due so that's why I am calibrating it now. I do not remember how I was able to calibrate it before but now I just can't seem to get it to work. I tried deleting and remaking the tip but still gives me the same issue. Please any help is greatly appreciated.
Hi all
i want a immediate help to advice to calibrate a L probe which is stopping when we start calibrating on DCC.the error is not in circle..pls help..
I recommend you start a new thread and detail your issue. It will give you the best opportunity to receive the useful information that is needed to help you through your issue.
Screenshots of probefile and calibration settings can also be great helps to gain the proper advice quickly.
I'd recommend, off hand, checking that the L tip is built to the proper rotation about the shank as it is considered in the probe build itself.
I recommend you start a new thread and detail your issue. It will give you the best opportunity to receive the useful information that is needed to help you through your issue.
Screenshots of probefile and calibration settings can also be great helps to gain the proper advice quickly.
I'd recommend, off hand, checking that the L tip is built to the proper rotation about the shank as it is considered in the probe build itself.
