Hello all,
I've recently been in the Code Samples forum asking you all for
some unusual questions.
This unusual question may not require a script. So here goes.
Does anyone know of a way to have an arrow snap to the DimensionInfo Label
to point in the direction a hole would have to move to be at it's nominal location?
EX. A hole with TP of .005 tolerance and an X deviation of +.003 and a Y deviation of -.004 from
nominal. Have arrows snap to the correct side of the label and point to the nominal location.
Hopefully that explains it without graphics.
Any suggestions would be appreciated.
position tolerances have such a target circle, where you actually get a good understanding in which direction the holes are shifted.
maybe that's a workaround?
otherwise you have to make a costume label, which I consider to be quite time-consuming
position tolerances have such a target circle, where you actually get a good understanding in which direction the holes are shifted.
maybe that's a workaround?
otherwise you have to make a costume label, which I consider to be quite time-consuming