Small Probe diameter during calibration

Hi guys, due to the amount of vibration in the shop here we have to switch between analog and TTP. I have been using Analog up until today but then I switched over to TTP and I'm getting small probe diameters on calibration.

I am trying to calibrate a TP20 system and my probe diameter keeps measuring around 1.972 (2mm ball) I have adjusted the touch speed from 6mm/Sec all the way down to 2mm/Sec with no changes in probe diameter.

Do I need to go into the Probe force settings and start messing around ? and if I do this will it interfere with my Analog settings?

Thanks!

Attached Files

Parents

Smasherofprobes over 1 year ago

Much better results using 3 rows / 9 hits !
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Smasherofprobes over 1 year ago

Much better results using 3 rows / 9 hits !
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Matthew D. Hoedeman over 1 year ago in reply to Smasherofprobes

ya sorta gotta think of circles and a pattern that will make circles, that's why I don't like the 9/4 as it doesn't make very good circles....
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel