hexagon logo
Register Sign in
  • Replies 27 replies
  • Subscribers 222 subscribers
  • Views 300 views
  • Users 0 members are here
Options
Related

Small Probe diameter during calibration

Smasherofprobes
Hi guys, due to the amount of vibration in the shop here we have to switch between analog and TTP. I have been using Analog up until today but then I switched over to TTP and I'm getting small probe diameters on calibration.

I am trying to calibrate a TP20 system and my probe diameter keeps measuring around 1.972 (2mm ball) I have adjusted the touch speed from 6mm/Sec all the way down to 2mm/Sec with no changes in probe diameter.

Do I need to go into the Probe force settings and start messing around ? and if I do this will it interfere with my Analog settings?

Thanks!

​
Attached Files
Parents
  • I just replaced the tp200 (RBE).
    Is it possible, that the new TP200 shows smaller probe diameters?
    For example 1 X30 mm probe on old TP200 showing diam 0.979,on new is 0.962​
    Is this normal,that every TP200 showing bit different, or something is wrong?
    I replaced only this, rest of the components are same as before.
Reply
  • I just replaced the tp200 (RBE).
    Is it possible, that the new TP200 shows smaller probe diameters?
    For example 1 X30 mm probe on old TP200 showing diam 0.979,on new is 0.962​
    Is this normal,that every TP200 showing bit different, or something is wrong?
    I replaced only this, rest of the components are same as before.
Children
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement