Does it matter what you set your depth at for a thread once you enter in the pitch? Do you just eye ball it and make sure the hits are inside the thread? Is there a way to calculate the depth the hits should be at? Just want to make sure I'm getting the right hits on the threads.
I think that will vary depending on the size of the thread and chamfer / edge break size. So many variables. Blind hole or really thin material ? I usually use 0-720 ° so I get 2 full revolutions in the thread as well when possible.
I think that will vary depending on the size of the thread and chamfer / edge break size. So many variables. Blind hole or really thin material ? I usually use 0-720 ° so I get 2 full revolutions in the thread as well when possible.