"I am measuring this Ring Gage Manually both the Height and the Width. When I move the probe in the Y direction, I get a good Deviation from Nominal. Then I try doing hits in the X Direction and it’s showing out half a mil. But if I turn the Ring Gage in the Y direction to measure the other half, it comes out good. I hope I explained this well enough lol. Pretty much my X direction is showing out but when I rotate it to the Y Direction, it shows up good." I tried changing Wrist Angles and its still showing a half mil deviation. I am in contact with Hexagon but just wanted to see if anybody has ran into this problem before. I have attached an image.
Is the slow button turned on while you're measuring? If you're slow button is not on during manual measurements, the machine is not going to be accurate.
Peter, Yes I have the "turtle button turned on" lol. I thought about that also. My temperature Scale is good also on the X. I'm running out of ideas. It is just odd to me.
Peter, Yes I have the "turtle button turned on" lol. I thought about that also. My temperature Scale is good also on the X. I'm running out of ideas. It is just odd to me.