I am measuring a datum cylinder for my alignment. First doing a manual alignment then dcc alignment both using the cylinder. To report the diameter of the cylinder is it acceptable to use the dcc measurement of it that was used for the dcc alignment? I guess this is more of a good practice type of question. Thanks in advance.
I play it safe and remeasure my manual alignment in DCC mode to correct errors in my manual vectors and variation in measurement speed, then I measure my datums from that "rough" DCC alignment. From the datums I will create whatever datum "fine" alignments I need.
I play it safe and remeasure my manual alignment in DCC mode to correct errors in my manual vectors and variation in measurement speed, then I measure my datums from that "rough" DCC alignment. From the datums I will create whatever datum "fine" alignments I need.