How to Reset all Actuals to Theoreticals?

Moved my part and even though I am doing a manual alignment it wont forget the previous actuals and crashes.

Edit: or perhaps I need to do something to make my manual alignment do its thing on the second part?
Edit: realizing my alignment is based on a constructed line and it looks like the constructed line is not "reconstructing" itself after I moved the part and started the execution from the top.

Parents

Jegley over 1 year ago

So what is the exact issue? that after moving the part you cannot set up the alignment again? As for the constructed line, it should be fine as long as you manually probe the correct features that actually construct the line.

The constructed line is not reconstructing to the new manually measured hole and center point that it is constructed from. If there is a way to just reset all the measured values it would help greatly.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Jegley over 1 year ago

So what is the exact issue? that after moving the part you cannot set up the alignment again? As for the constructed line, it should be fine as long as you manually probe the correct features that actually construct the line.

The constructed line is not reconstructing to the new manually measured hole and center point that it is constructed from. If there is a way to just reset all the measured values it would help greatly.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data