command spacing in command mode get spaced farther and farther apart

DanielJStoner over 1 year ago

What is going on with the spacing here? (See pic) Then my program skips over a section and runs something different.

Attached Files

bfire85 over 1 year ago

First off, do not use anything but letters, numbers, or underscores in any naming convention. Are there spaces after the naming?

Secondly, what version are you using?

Third, do you have any IF/END_IF, DO/UNTIL, WHILE/END_WHILE statements?

Otherwise, try bouncing between summary mode and command mode to see if that fixes it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
DanielJStoner over 1 year ago in reply to bfire85

THANK YOU for your response! I have no if/end statement. What in the program would make it jump forward? That command?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
DanielJStoner over 1 year ago

I'm trying to figure out if there was a specific "keystroke" that put this in this mode. Does anyone know of any?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
RobOntario over 1 year ago

First off, do not use anything but letters, numbers, or underscores in any naming convention. Are there spaces after the naming?

Secondly, what version are you using?

Third, do you have any IF/END_IF, DO/UNTIL, WHILE/END_WHILE statements?

Otherwise, try bouncing between summary mode and command mode to see if that fixes it.

Dot not in the list.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
DanielJStoner over 1 year ago in reply to RobOntario

Yep! I just re-wrote 1/3 of program over WITHOUT (.'s)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
russell dunham over 1 year ago in reply to bfire85

Is there any GROUP commands? I've used these in the past but won't use them as they have broken some programs while I used the command.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel