Utterly confused by this print, I'm guessing they want a runout of 0.008 between the major of the spline and the stock shaft OD but is this called out correctly? Thanks
The runout to itself does not make any sense. For the spline, datum A is not the OD, but the axis of the Ø1.496-1.500, but I would also interpret this as the runout of the spline Major Diameter relative to the axis of cylinder Datum A since it is attached to the Major. If it were attached to the spline callout, I would ask the customer what they want
The runout to itself does not make any sense. For the spline, datum A is not the OD, but the axis of the Ø1.496-1.500, but I would also interpret this as the runout of the spline Major Diameter relative to the axis of cylinder Datum A since it is attached to the Major. If it were attached to the spline callout, I would ask the customer what they want