Utterly confused by this print, I'm guessing they want a runout of 0.008 between the major of the spline and the stock shaft OD but is this called out correctly? Thanks
That is a wacky callout. First of all, the diameter is a Reference feature. But they decided to put a circular runout callout on it - relative to itself?
If it were a total runout callout, I would interpret it as they want the cylindricity, but they have something 'special' there.
That is a wacky callout. First of all, the diameter is a Reference feature. But they decided to put a circular runout callout on it - relative to itself?
If it were a total runout callout, I would interpret it as they want the cylindricity, but they have something 'special' there.
