Utterly confused by this print, I'm guessing they want a runout of 0.008 between the major of the spline and the stock shaft OD but is this called out correctly? Thanks
The rightmost runout is using the datum triangle to connect to the feature, is that datum A then?
The leftmost runout has the datum not connected to the centerline, meaning that datum A is the surface (generatrix).
I'd say you need clarification from the designer and a revised drawing.
The rightmost runout is using the datum triangle to connect to the feature, is that datum A then?
The leftmost runout has the datum not connected to the centerline, meaning that datum A is the surface (generatrix).
I'd say you need clarification from the designer and a revised drawing.