I have a problem with reporting position of a hole.
I'm a bit confused of how to report this in pcdmis.
Using PC-DMIS 2017 R1 SP10
Drawing frame:
ASME Y14.5
Is this correct?
If it is, then what is the actual bonus of position? Also do I take into account deviations of Dat A and Dat B?
What is my actual result and what is the bonus.
Ok, I've found some reports from newer full dim program that i did in December, and there's no problem without MMB size declaration.
So the dev = 0 must be a problem with the code or some alignments
Ok, I've found some reports from newer full dim program that i did in December, and there's no problem without MMB size declaration.
So the dev = 0 must be a problem with the code or some alignments