We have recently started to replace our ruby tip probes with silicon nitride tips. However, we haven't been able to use any of them because we keep getting the "probe calibration exceed limit" error. All of our ruby tips calibrate fine. Has anyone else ran into this issue? Any trouble shooting ideas? I've done everything I can think of.
.0006 and some change. I was told not to change any of limits. I wasn't sure if a silicon nitride tip should have different limits. I've also reached out the Renishaw to see if they have any info on my this tip is failing calibration.
.0006 and some change. I was told not to change any of limits. I wasn't sure if a silicon nitride tip should have different limits. I've also reached out the Renishaw to see if they have any info on my this tip is failing calibration.