Pass fail to tolerances

Here is my problem. If I say I only want to report 3 digits and .005+/-.001 and the result is .0061 it will show me a fail. I want it to show me a pass. Same with .0039 want to show as a pass.

Anything in the software that I can turn on to correct the pass fail with that?

Any thoughts would helpful can think of some work arounds.

Parents

KatmandudaMeow over 1 year ago

so you want to lie haha you could always assign the dim as a variable and give it an if statement to handle the number according to what you want it to do dimensionally
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

KatmandudaMeow over 1 year ago

so you want to lie haha you could always assign the dim as a variable and give it an if statement to handle the number according to what you want it to do dimensionally
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Kai Kendall over 1 year ago in reply to KatmandudaMeow

Some agencies actually specify what he is looking for.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
KatmandudaMeow over 1 year ago in reply to KatmandudaMeow

What you want to achieve is in direct violation of ASME Y14.5 Section 2.4 (this is from ASME Y14.5-2009)

{"data-align":"none","data-size":"full","title":"image.png","data-attachmentid":530779}

see what Mike Ruff posted...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel