Here is my problem. If I say I only want to report 3 digits and .005+/-.001 and the result is .0061 it will show me a fail. I want it to show me a pass. Same with .0039 want to show as a pass.
Anything in the software that I can turn on to correct the pass fail with that?
Any thoughts would helpful can think of some work arounds.
If he's got an SOP that states thout shall round for all drawings, and this SOP is accepted by their customer(s), then thout shall round per that SOP!
--The only exception is when it comes to conducting a gage study (MSA). You should never apply rounding to a gage study.
FYI, you can actually further obscure (or control) the dim tolerances by making the tolerances on each dim point to an assignment variable.
Here's a truncated segment of a routine I made that parametrically shifted tolerances so any time we run the routine with a "qualification" toggle, it refers to the GAGERR dim values
END_IF/
ELSE/
$$ YES,
GREEN SPEC GRAY OUTER BODY
ASSIGN/TOL_AA_P=0.01
ASSIGN/TOL_AA_M=0.02
END_ELSE/
END_ELSE/
DIM AA_GATE_1= 2D DISTANCE FROM PLANE APLANE_1 TO POINT AD_GATE_1 PAR TO YAXIS,NO_RADIUS UNITS=IN,$
GRAPH=OFF TEXT=OFF MULT=10.00 OUTPUT=BOTH
AX NOMINAL +TOL -TOL MEAS DEV OUTTOL
M 5.378+0 TOL_AA_P TOL_AA_M 5.37762 -0.00038 0.00000 --#-
ooh there's an extra else as there were two part variants (resin type/color). I have unique dims for color 'A' and a second set of unique tolerances for the gray in the above code.
ooh there's an extra else as there were two part variants (resin type/color). I have unique dims for color 'A' and a second set of unique tolerances for the gray in the above code.