This isn't a PC-DMIS question but I thought someone here might know the answer. What is the logic behind having a Ø called out at 20.0mm with a -.007 / -.04 tolerance. Why not just make the Ø19.993 +0 / -.033?
I number of years ago I had a similar callout with a +/+ tolerance. The engineers designed it that way because it was a press fit pin that went into the hole. I shook my head and walked away.
I number of years ago I had a similar callout with a +/+ tolerance. The engineers designed it that way because it was a press fit pin that went into the hole. I shook my head and walked away.