How do I avoid the below situation of a scan? I know I can turn them to points and have clearance moves around the problem prone ones, but that method hurts my eyes and my patience.
I could also adjust prehit and retract, but the time would slow down a bit for the scan.
there is a 'VARIABLE' method for scans where you enter in the MAX & MIN INCREMENT and the MAX & MIN ANG so that Pcdmis will adjust the distance between the hits based on the 'rate of change' of the surface. I've never been able to get it to work worth a crap (in "learning" mode where I would use it), but maybe you will have better luck using it on CAD. It will the tighten up the spacing around those corners so you shouldn't get those issues
there is a 'VARIABLE' method for scans where you enter in the MAX & MIN INCREMENT and the MAX & MIN ANG so that Pcdmis will adjust the distance between the hits based on the 'rate of change' of the surface. I've never been able to get it to work worth a crap (in "learning" mode where I would use it), but maybe you will have better luck using it on CAD. It will the tighten up the spacing around those corners so you shouldn't get those issues
