I am using a 0.7X20mm probe (long thin shaft). What are the best calibration settings for this probe? It keeps failing calibration for a few tip angles (.0004 deviation). I am using DCC+DCC 31 hits (5 levels) with a start angle of 10 and end angle of 90.
Sorry but I'm going to piggyback on this string. I just ordered a 0.5 x 20 stylus that I'm going to put on a Leitz LSPX1C probing system of an Optiv vision system.
What optional probe settings are you folks using for this configuration?
Sorry but I'm going to piggyback on this string. I just ordered a 0.5 x 20 stylus that I'm going to put on a Leitz LSPX1C probing system of an Optiv vision system.
What optional probe settings are you folks using for this configuration?