We are doing a short run project for a company. We are a stamping factory. They want to stamp out a flat "V" shaped retention spring out of 0.018" thick steel and measure 0.010" flatness,
unrestrained. I usually deal with material that is thicker than this. Anyone have any ideas?
dwade How do take into account if the part is potato chip and you are only looking at it in one viewplane? You won't be able to see the "bow". I'm not trying to be difficult here I'm just trying to work out the best way to check this thing if I were in OP's shoes. *smooches*
dwade How do take into account if the part is potato chip and you are only looking at it in one viewplane? You won't be able to see the "bow". I'm not trying to be difficult here I'm just trying to work out the best way to check this thing if I were in OP's shoes. *smooches*