I have a quick question. Attached are 2 different prints. One is a GD&T Datum Scheme and the other is an Assembled Datum Scheme. They want me to run two different datum schemes and compare results. What is the best way to Align each Print? Its going to be a singular part that I'm programming.
Must use iterative alignment, treating datum targets shown as zones, as if they were precise points. You'll need each datum target described in all 3 dimensions. Set alignment tolerance to about 50-100 microns.
Must use iterative alignment, treating datum targets shown as zones, as if they were precise points. You'll need each datum target described in all 3 dimensions. Set alignment tolerance to about 50-100 microns.