I am new to PC-DMIS and our machine was just installed. As I am constructing my manual alignment, I am asked "Do you want to make Y- or X+ the active workplane? I didn't notice this at the training center. Should I use the "don't ask me this again" in this case?
DO NOT approve the "DON'T ASK AGAIN" as you are doing something wrong right now, and that is the only warning you will get that you are doing something wrong. Like, measuring a circle in the XZ plane (Y workplane) while the Z is the active work plane.
DO NOT approve the "DON'T ASK AGAIN" as you are doing something wrong right now, and that is the only warning you will get that you are doing something wrong. Like, measuring a circle in the XZ plane (Y workplane) while the Z is the active work plane.