I am new to PC-DMIS and our machine was just installed. As I am constructing my manual alignment, I am asked "Do you want to make Y- or X+ the active workplane? I didn't notice this at the training center. Should I use the "don't ask me this again" in this case?
yes, you should be OKAY as long as there is enough arc for the machine to see that it isn't a line, but is in fact an arc. Of course, AFTER the feature is created, it KNOWS it is an arc, and will comp correctly. You may have to do an X+ tounch to a Y+ touch to learn it, but once created, it's fine. NO probe comp is done until ALL touches are measured
yes, you should be OKAY as long as there is enough arc for the machine to see that it isn't a line, but is in fact an arc. Of course, AFTER the feature is created, it KNOWS it is an arc, and will comp correctly. You may have to do an X+ tounch to a Y+ touch to learn it, but once created, it's fine. NO probe comp is done until ALL touches are measured