How do you go about creating a width, for a position callout, on a surface with draft present. When creating a width the features must have opposing surface vectors however, when a feature has draft the CAD nominal vectors are not perfectly opposed. Normally I would create a midpoint between the surfaces and report the position of that point but when MMC is applied it wont calculate bonus tolerance. Are there any solutions for this?
Construct auto features for both planes, after you create them just change your THEO to a perfect vector surface, that will allow you to make a width then you can position it.
I don't believe its the same vector issue, its that the draft has angled planes not opposing each other.
That is correct. Technically, a slot with draft on the sides would be what the standards refer to as a "wedge". PC-DMIS does not support a wedge feature yet.
I don't believe its the same vector issue, its that the draft has angled planes not opposing each other.
That is correct. Technically, a slot with draft on the sides would be what the standards refer to as a "wedge". PC-DMIS does not support a wedge feature yet.
