Got a part with a lager Id bore that is datum b. Going into the part morr is a smaller bore with a position of .003 to b.
So my fcf used the drf to control it. Well the report does not show x and z as zeros. Engineering says datum b is zero so the report has to show everything as zero. So I did an alignment using just datum b( center line of the cylinder) the report show zeros but bad position and does not repeat. What am I missing
What is the length of Datum B? How are you aligning? Are you Leveling to the Axis and Origin, what stops rotation? How far linearly is the measured feature to Datum B
What is the length of Datum B? How are you aligning? Are you Leveling to the Axis and Origin, what stops rotation? How far linearly is the measured feature to Datum B