Got a part with a lager Id bore that is datum b. Going into the part morr is a smaller bore with a position of .003 to b.
So my fcf used the drf to control it. Well the report does not show x and z as zeros. Engineering says datum b is zero so the report has to show everything as zero. So I did an alignment using just datum b( center line of the cylinder) the report show zeros but bad position and does not repeat. What am I missing
Datum b is .50 imchs. My Original alignment was based off of the drawings a b and c datums. My feature control frame was using a b n c as a data reference feature. My future control frame was a true position to threecell at b. I created b as a datum off of the center of that cylinder. Engineering disagreed with the way I have that aligned. They want to see datum b as an alignment to itself. It is not leveled. It has nothing controlling rotation.
Datum b is .50 imchs. My Original alignment was based off of the drawings a b and c datums. My feature control frame was using a b n c as a data reference feature. My future control frame was a true position to threecell at b. I created b as a datum off of the center of that cylinder. Engineering disagreed with the way I have that aligned. They want to see datum b as an alignment to itself. It is not leveled. It has nothing controlling rotation.