Got a part with a lager Id bore that is datum b. Going into the part morr is a smaller bore with a position of .003 to b.
So my fcf used the drf to control it. Well the report does not show x and z as zeros. Engineering says datum b is zero so the report has to show everything as zero. So I did an alignment using just datum b( center line of the cylinder) the report show zeros but bad position and does not repeat. What am I missing
I truely hope none of the guys on here are our customer. I hope these parts fail. And get kicked back. Sometimes management needs that kick in the pants to plan and understand better. Cost of quality
I truely hope none of the guys on here are our customer. I hope these parts fail. And get kicked back. Sometimes management needs that kick in the pants to plan and understand better. Cost of quality