New user here, still running into hurdles. I’m running a program that has successfully run in DCC mode on a previous part, loaded a second part and the probe fails to trigger after the alignment. I first probe 4 points to establish my Z plane, 4 points around the OD of the part to establish my X and Y zeros, do the alignment and then start to probe points for a second plane. The probe is moving vertically towards the surface but it fails to trigger. It keeps moving in the Z negative direction until it alarms out. Any help appreciated.
Thanks, Glenn
Check for magnetism in the part. Normal TP20 modules are effected by magnetic fields, and will do just that, not trigger and keep trying to move through the part.
Check for magnetism in the part. Normal TP20 modules are effected by magnetic fields, and will do just that, not trigger and keep trying to move through the part.