New user here, still running into hurdles. I’m running a program that has successfully run in DCC mode on a previous part, loaded a second part and the probe fails to trigger after the alignment. I first probe 4 points to establish my Z plane, 4 points around the OD of the part to establish my X and Y zeros, do the alignment and then start to probe points for a second plane. The probe is moving vertically towards the surface but it fails to trigger. It keeps moving in the Z negative direction until it alarms out. Any help appreciated.
Thanks, Glenn
Thanks Matthew. We do not have a rack, or a demagnifier or a TP20 NI. It looks like we are going shopping. Its kind of a relief that my program was OK and the machine hadn't lost its mind.
Thanks Matthew. We do not have a rack, or a demagnifier or a TP20 NI. It looks like we are going shopping. Its kind of a relief that my program was OK and the machine hadn't lost its mind.