I am hitting a major block in my programing for a cylindrical part.
After importing the CAD model and establishing an alignment, my trihedron is right where I want it. using a top plane to level the part and establish translation in Z, an I.D. bore which is datum B measured as a cylinder for translation in X and Y, and two side holes 180 degrees measuring as circles and constructing a cylinder to use as my rotating feature in the hopes that will clock the part during the program in case operators put the part in slightly off .
Unfortunately, after testing out my manual alignment everything looks good except the I.D. cylinder doesn't snap correctly to the CAD model and it looks like it is on an angle.
I know that isn't to much to go on but I am completely unsure of what I may be doing wrong. If possible, please help
Did you switch to probe mode when programming and click the model (all in off-line) to get where the (approximate) hits would be off the CMM during on-line manual?
Or, if you have sufficient features for it to work, did you do CAD=Part?
If you do neither, the software has no way to "KNOW" that you meant it to be the cad.
Unless you put the model in model coordinates at -14.653, -4.362, -8.932 and then placed that part EXACTLY in those coordinates on the machine, you didn't actually MEASURE points where the model "IS" electronically.
You have to be off-line, in probe mode, and click the surfaces then hit end (3-4 hits for a plane, end / 3-4 hits for a diameter, end / etc.) so it knows you mean it to be there.
Or you can measure and then translate the model (Operation -> Graphic Display Window -> Transform) to match what you measured. You're going to get a pop-up saying the program won't move, just the cad. Because, the CAD isn't strictly, explicitly, tied to the program, which is why you have to make it match somehow.
Did you switch to probe mode when programming and click the model (all in off-line) to get where the (approximate) hits would be off the CMM during on-line manual?
Or, if you have sufficient features for it to work, did you do CAD=Part?
If you do neither, the software has no way to "KNOW" that you meant it to be the cad.
Unless you put the model in model coordinates at -14.653, -4.362, -8.932 and then placed that part EXACTLY in those coordinates on the machine, you didn't actually MEASURE points where the model "IS" electronically.
You have to be off-line, in probe mode, and click the surfaces then hit end (3-4 hits for a plane, end / 3-4 hits for a diameter, end / etc.) so it knows you mean it to be there.
Or you can measure and then translate the model (Operation -> Graphic Display Window -> Transform) to match what you measured. You're going to get a pop-up saying the program won't move, just the cad. Because, the CAD isn't strictly, explicitly, tied to the program, which is why you have to make it match somehow.