I have a part that I need to do a FAI on that has over 700 dimensions. I was planning on splitting it up into several smaller programs. I believe I can get most of the features in 1 setup, so I was going to use external alignments. What I need help on is, a lot of the dimensions needed have modifiers on the datums. How can I get the datum features from a previous program into a current program so I can take advantage of the bonus available on the datum features?
Can you construct features or create variables from the datums in your attached measurement routine? You may be able to re-create your datums that way.
Can you construct features or create variables from the datums in your attached measurement routine? You may be able to re-create your datums that way.
Trying that now JesseB413.
I thinking I need to do (PLNA.TX, PLNA.TY, PLNA.TZ , PLNA.TI, PLNA.TJ, PLNA.TK)
(PLNA.X, PLNA.Y, PLNA.Z , PLNA.I, PLNA.J, PLNA.K)
Something like that I'm guessing.
Need to create top plane, bottom plane, then construct a WIDTH for my datum!