I left my job for 3 months & they talked me into returning. While I was gone, they bought a new CMM. We originally ran PCDMIS 3.7MR2. They upgraded to PCDMIS 2023. They tried to run my 3.7 MR2 programs & were told they would not run; they were told to install PCDMIS 2015 & the programs would then run. The issue I am having is the old probe files had a RENISHAWPH10MQ head & the new CMM has a Hexagon probe head. When I create a new probe file with the Hexagon head & only add a A0,B0 angle the probe sometime takes all 9 points as it should, sometimes it takes 3 points they goes off into the X+, One time it went in in a circular motion & hit the surface plate. The probe is doing things that make absolutely zero sense. I know it's a long shot, but does anyone have any input??
