An operator called me out to the shop floor with an issue calibrating the probes under operator mode. The first probe calibrated fine, but the second probe wouldn't pick up at all and gave the error message below. Any idea how I can get this to work and pick up the second probe and calibrate it?
Was the calibration sphere in a safe location that the probe should have been able to calibrate at?
Have any of the setup parameters been modified in the probe utilities box to adjust the movements around the calibration sphere position?
Was the calibration sphere in a safe location that the probe should have been able to calibrate at?
Have any of the setup parameters been modified in the probe utilities box to adjust the movements around the calibration sphere position?