Hope everyone is well on this Friday. I have a decent issue on my hands. I'm measuring a few parts to get a feel for what the numbers are. The first part was a completed part that inspected all the features. The next two parts are missing a giant bore in them. But wanted to check the position of some other holes.
The problem I'm having is that, my report shows the same numbers as from the first part. Its not updating to the newly measured parts. Any idead to as what I'm doing wrong? Thaks for your time.
If you're reporting all dimensions at the end of the program rather than after every feature measured, then the report is not updating if you stop the routine after the feature is measured but before you get to the dimension...if I understand the question correctly....
If you're reporting all dimensions at the end of the program rather than after every feature measured, then the report is not updating if you stop the routine after the feature is measured but before you get to the dimension...if I understand the question correctly....