Hope everyone is well on this Friday. I have a decent issue on my hands. I'm measuring a few parts to get a feel for what the numbers are. The first part was a completed part that inspected all the features. The next two parts are missing a giant bore in them. But wanted to check the position of some other holes.
The problem I'm having is that, my report shows the same numbers as from the first part. Its not updating to the newly measured parts. Any idead to as what I'm doing wrong? Thaks for your time.
End of dimension item#10/11 diameter/position of datum c to ab
dim item#13_diameter of datum b= location of circle datum_b units=in ,$
graph=off text=off mult=10.00 output=both half angle=no
ax nominal +tol -tol meas dev outtol
d 1.2800 0.0050 0.0050 1.2793 -0.0007 0.0000 --#--
End of dimension item#10/11 diameter/position of datum c to ab
dim item#13_diameter of datum b= location of circle datum_b units=in ,$
graph=off text=off mult=10.00 output=both half angle=no
ax nominal +tol -tol meas dev outtol
d 1.2800 0.0050 0.0050 1.2793 -0.0007 0.0000 --#--