Hello, I am determining the position of points B1 and B2. There is no problem with position B1, but with the position of point B2, the position is displayed outside the given point. I don't understand why, the problem will probably be in the measured element, but the measurement and evaluation procedure of both elements is the same. Does anyone have experience please?
EDIT:The moment I turned on the text search in the log for the position of point B1, the results jumped by more than 4mm! What it should be?? I'm mad >
Degrees of freedom: The number of unique ways in which a part can move in an alignment system. In static alignment, there are six: one in the direction of and one in rotation about each of the X, Y and Z axes.
A good alignment locks all of these in place. It sets the origin in X, Y & Z. Typically (but not always) these are your first 3 datums (A, B, C)
Degrees of freedom: The number of unique ways in which a part can move in an alignment system. In static alignment, there are six: one in the direction of and one in rotation about each of the X, Y and Z axes.
A good alignment locks all of these in place. It sets the origin in X, Y & Z. Typically (but not always) these are your first 3 datums (A, B, C)
