I have a 5 sided square slot. The top is the open side. The print calls for a mmc position tolerance on the pocket/slot I am referencing however the program I am using has the position programmed as two opposing sets of planes, each set has a midpoint constructed between them and the position is applied to the point.
How do I construct the pocket as it's own complete feature (all 5 sides of the square, with the top open) and allow for the size of that feature to apply itself to the bonus tolerance of the position of the feature?
Thanks for the advice. I am going to level 2 and 3 training this month so hopefully I will get more answers. I will give these suggestions a try the next time those parts come through. I can see how converting the square with T.P. to a circle or cylinder would work for allowing bonus from the feature but I am not sure how well it would work for something like creating a MMB from a datum, however I have not tried constructing a feature of size as a width and trying to apply it in Xact, only tried it in legacy. I also don't think the 2015 version has GeoTol? Great info. I'll repost when I try these.
Side note: Does anyone know what I can expect from level 2 and 3 training?