Over time when I run a program and hit cltr+U to start it it takes sometimes upwards of a minute to start. Compared to when I created the program it started almost immediately. My theory is that the program is keeping all of the output dimensions logged somewhere so it is bloating the program. I've tried using the print command to delete previous instances however that only seems to "delete" the from the current report display. I say this because I can remove the line and it will show my previous measurements again if I open the report window.
How do I prevent the program from getting slower the more I run it?
Reset will reset the execution list which the report uses to generate. Each re-execution of a command causes the command to be duplicated and added to the list. Full execution clears the list before starting. The report is just using the commands currently in the list.
Reset will reset the execution list which the report uses to generate. Each re-execution of a command causes the command to be duplicated and added to the list. Full execution clears the list before starting. The report is just using the commands currently in the list.