We just installed the 2023.2 release on our two cmms. The issue is when we open the 2023.2 version we have the icon box machine not responding on one cmm and then with the other cmm we have an error in connect=0. A side note this was done on the night shift, I am just trying to help out and see if I could reach out here before having to get tech support if its not needed. We are currently running 2022.1 version.
2022.1 was the version using, our SMA is good. No loose wiring, runs fine with 2022.1 version. I believe the config were backed-up but will verify and go through and recall on the new install.
2022.1 was the version using, our SMA is good. No loose wiring, runs fine with 2022.1 version. I believe the config were backed-up but will verify and go through and recall on the new install.