Measure bolt holes circles

Hi everyone,
Please help as I tried to measure the bolt circle angle but it showed zero value on the report as attached photo.. I created 2 lines from center of bolt circle to the 2 small circles, it showed correct the nominal value from CAD but no measure value on the report ..
I selected YPlus as working plane
Thanks so much

Attached Files

Parents

KTM4012 over 1 year ago

Did you try a different workplane?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

KTM4012 over 1 year ago

Did you try a different workplane?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

anthonyT over 1 year ago in reply to KTM4012

Hi ,
The Bolt circles and the constructed lines resides in Y+ plane as the photo shown attached on the post. I can see the angle looked but there is no measured value at all. Not sure what Idid wrong...
I tried on different workplane and it did not even shown nminal value or any measurement at all
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel