CMM measuring dimensions incorrectly

PC-DMIS 2020R1

I am having an issue with the CMM measuring dims out of tolerance. Screen shot of the CMM report is attached. A lot of these programs are from 2017 or 2018. They are not using CAD models. The CMM was calibrated Aug 2023. I'm very stuck on what else to look into.

I thought maybe it was a migration issue but this is a recent issue. Within the last 8 months.

I tried setting the FCF instead of using the x,y and z from measurements. i tried using the back up program. program is using a star probe so i switched it to a rotating probe, still didn't work.

Attached Files

Parents

JacobCheverie over 1 year ago

All of your reported results are from your active alignment. If you align, properly, to your datum features your results should match a manual measurement (if you're physically locating on your datum features in the appropriate way).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

JacobCheverie over 1 year ago

All of your reported results are from your active alignment. If you align, properly, to your datum features your results should match a manual measurement (if you're physically locating on your datum features in the appropriate way).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Shay** over 1 year ago in reply to JacobCheverie

I didn't make this program. it was before my time at this company. Are you saying I should have the part alignment match the datums from the drawing? The datums are set in the program.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel