Hello fellow Metrologist!
My question is going to be geared more to the Gurus here on PC DMIS forum; I have an aerospace part that has target points A1,A2,A3,B1,B2,C1 ....I know how to create an iterative alignment...however, what I usually do is make a readpoint in a location where I can do a small alignment, changing the location of the trighedron...However, the customer has supplied the CAD and wishes for us to keep the location were it is....its in a place you could not create a readpoint without going through the part.
How do i create a readpoint that goes directly into the iterative?
Thanks in advance.
We have started using 2 Readpoints in holes or on pins and 1 vector point in manual or DCC to establish the first Iterative datum, then use DCC Iterative to establish the print ABC as required.
HTH!
We have started using 2 Readpoints in holes or on pins and 1 vector point in manual or DCC to establish the first Iterative datum, then use DCC Iterative to establish the print ABC as required.
HTH!