I am currently trying to set up a liner scan and although I can see nothing within the set-up every time I perform the scan instead of scanning it takes points. The CMM, Head and probe are all capable of scans and have been used on other programs (2019) however since upgrading to 2023 I cant get it to scan and only take a scan using points.
Anyone know what the issue could be and how to resolve?
I'm not totally sure how but I've seemed to off solved the issue. All i did was re-run the scan again and it seemed to then start scanning rather than points.
I'm not totally sure how but I've seemed to off solved the issue. All i did was re-run the scan again and it seemed to then start scanning rather than points.