This hole is initially aligned as one of my primary datums (A, B, C), but its unclear to me how I can measure it against UVW to make THAT my C datum and then use it to measure it again against itself?
I understand this is probably 101, but I'm just not processing it.
well, just a guess, but you measure & report the 'width' (direction shown) to UVW, that 'width' is then the "C" datum, then the 'length' of the hole is reported to ABC.
Yeah, it is a round hole, so no width or length, but lacking better terms, those are what I used.
well, just a guess, but you measure & report the 'width' (direction shown) to UVW, that 'width' is then the "C" datum, then the 'length' of the hole is reported to ABC.
Yeah, it is a round hole, so no width or length, but lacking better terms, those are what I used.