This hole is initially aligned as one of my primary datums (A, B, C), but its unclear to me how I can measure it against UVW to make THAT my C datum and then use it to measure it again against itself?
I understand this is probably 101, but I'm just not processing it.
I guess you could:
-Scan the hole
-Use variables to assign high points at the X+, X-, Y+, and Y-
-Make widths out of the points
-Call the "X Width" your "Datum -C-"
-Create alignment as needed
-Dimension accordingly
I guess you could:
-Scan the hole
-Use variables to assign high points at the X+, X-, Y+, and Y-
-Make widths out of the points
-Call the "X Width" your "Datum -C-"
-Create alignment as needed
-Dimension accordingly