Trying to setup an ABC alignment. A and B are no problem. Tried constructing a circle through C holes but ‘math failed’. X and Z are constrained with A and B. Y is a problem. Any ideas?
Much better!
C is the bolt hole pattern center defined by the basic dimension R18.400. Construct a mid point of the bolt holes using the basic angle of 8.75°. Then construct a line from the center to that "B" point.
Much better!
C is the bolt hole pattern center defined by the basic dimension R18.400. Construct a mid point of the bolt holes using the basic angle of 8.75°. Then construct a line from the center to that "B" point.